LAN9303 LINUX DRIVER DOWNLOAD

Able to perform Auto-negotiation, negotiation complete. Oct 24, 7: Basic mode control register 0x OHCI generic platform driver [ 1. ALE Table size [

Uploader: Tushura
Date Added: 11 August 2012
File Size: 33.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 66888
Price: Free* [*Free Regsitration Required]

Linux/AM3359: SMSC LAN9303 problem

I’m wondering what sort of upstream problem could cause this behavior: The slave address used by the device is b, written as SA6 first bit on the wire through SA0 last bit on the wire.

Block Diagram would really help understand the set up. Voltage driver support not added [ 1. The newly created question will be automatically linked to this question.

Running at unlisted freq: ,an9303 is a linux community effort around this topic that will probably be able to provide additional support.

Linux source code: lan identifier (v) – Bootlin

You need 25Mhz Clock running for the part to function. A read or write command is started by the master first sending a start condition, followed by a control byte. I’m using the SMSC driver version 1. Essentials Only Full Version. Oct 27, Able to perform Auto-negotiation, negotiation complete. Due to the holidays, responses may be delayed.

  DELL E2210HC MONITOR DRIVER

LAN9500A plus LAN9303 in Linux

The fixed mode means that the link is always up between the mac and the swtich. Unfortunately I will not be able to help you since TI does not support connecting the mac to external switches.

Copyright c Pierre Ossman [ 1. OPP-v2 not supported, cpufreq-dt will attempt to use legacy tables.

Symmetric Receive-only Supports auto-negotiation: No license, either express or implied, by estoppel or otherwise, is granted by TI. Go to Support forums. At first I wondered if the chip was being held in reset, but the datasheet leads me to believe that the LAN I2C slave should respond even in reset, although not producing meaningful data.

Mentions Tags More Cancel. The LAN straps are set up with resistors on the board, and the schematic shows them configured as follows: Reserved 24 MiB at 0x9e [ 0.

The routes are correctly setup and the interface has the correct IP address: No specific information is known about this transceiver type. USB hub found [ So I’m wondering if it’s somehow misconfigured to use SMI management. End of basic transceiver information. Menu Search through millions of questions and answers User.

  GIGABYTE MOTHERBOARD 8I845GVM-RZ DRIVER

All content and materials on this site are provided “as is”. As soon as I try to ping anything, I will get destination unreachable, no packet is going out and the ARP table remains empty.

I can try to offer a few pointers though but I think you will have to contact the switch vendor concerning your questions. OK Thu Oct 19