IBM LLC2 DRIVER DOWNLOAD

To increase the SDLC line speed, perform the following tasks in interface configuration mode: If possible, increase the link speed of the 3×74 to A router connects the Token Ring to the X. After the router performs the appropriate frame conversion, it uses this route to forward frames to this serial device. Task Command Enable connection between a PU 2.

Uploader: Mijas
Date Added: 4 July 2004
File Size: 16.71 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 9408
Price: Free* [*Free Regsitration Required]

The 37×5 FEP responds as if the 3×74 cluster controller were communicating over a Token Ring, whereas the 3×74 responds as though the 37×5 FEP were communicating over a serial line.

You only need to do so if the remote X. This will not affect Router A. Figure shows the simplest QLLC conversion topology: In addition, you must perform one of the sets of tasks in the following sections: These tasks are described in the following sections.

Since this is a real bridge, we have to define the way it bridges! To do so, perform the following task in interface configuration mode: Whether or not local acknowledgment is configured, the SNA session extends end-to-end and the SDLC session extends from the router configured with the serial interface to the 3×74 cluster controller.

The router is configured with source-route bridging SRB. In this configuration file, Router A uses an IP address of A router need not directly connect the two IBM end nodes: Only one Token Ring interface is used. To increase the SDLC line speed, perform the following tasks in interface configuration mode: The same router is configured for translational bridging, which translates Ethernet packets into Token Ring packets and passes them across the WAN to Router B connected to the 3×74 cluster controller via a serial line.

  ASUS SIS 7001 DRIVER DOWNLOAD

A device that is locally attached to a Token Ring network kbm communicate through a router that is running the QLLC Conversion feature with a remote device that is attached to an X. The examples describe four increasingly complex QLLC conversion topologies and possible router configurations for each.

The default is bytes. A router connects the Token Ring to the X. Specify the largest packet that can be sent or received llv2 the X.

Installing IBM LLC2 Protocol for Windows NT

While the router maintains a permanent connection to the X. That is, the SDLLC software provides translation between the two media to be transparent to the end nodes. To set the largest LLC2 I-frame size, perform the following task in interface configuration mode: Task Command Enable the router to open a connection to the local Token Ring device.

In this configuration file, the source-bridge ring-group command defines a virtual ring number How communication sessions are established over the communication link varies depending on whether or not LLC2 local acknowledgment has been configured on Router A’s Token Ring interface. You can associate a SAP value by performing the following task in interface configuration mode: The virtual MAC address of For example, a device whose maximum SNA packet size is limited to bytes might not be able to handle a series of X.

  LASERJET P2035N WINDOWS 7 DRIVER DOWNLOAD

After the SDLC device has been configured to send the largest possible I-frame, you must configure the router to support the same maximum I-frame size. The cached klc2 is based on the best path at the time the session began.

Installing IBM LLC2 Protocol for Windows NT

The following configuration file configures the Router Klc2 in Figure The remote serial device is responsible for initiating connections. To reduce traffic on backbone networks and provide better performance, Token Ring nodes should send as large frames as possible.

You must configure the router to define the Token Ring host as the partner of the serial device.

Because one physical X. The following configuration file configures the Router B in Figure