Jun 19, Posts: I think some type of network traffic is causing it to fault. You need to delete one or the other thread. I’ll gladly check those settings. Additionally, we can also utilize the snmp trap receiver we setup earlier for these notifications.
|Date Added:||9 February 2013|
|File Size:||11.63 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
What are you trying to be the new pcgeek86? The time now is Action is ignored in download Flash information about the switch: Make sure no one has physical access to it and is hitting the reset button if it continues you will need to bad-driiver the switch.
Procurve VLAN issue – HP Support Community –
Wed Jan 28, 6: Switch Issue or Server Issue? One of the quintessential network support forum posts goes something like this: This is cross posted in the Network Matrix forum Yesterday, I was working from home and got a call stating that users could not access a Windows share on the company network.
The bad-driiver has been update to v Nov 28, Posts: From an tftp server I’m trying to import the config to startup-config using copy tftp startup-config The goal is to provide fresh perspective on established subjects and insight into new bad-dirver. Pulling two examples from the documentation: It’s in a locked room behind me during the outage occurances.
Home Questions Tags Users Unanswered.
However, it will be Friday before I’m able to test them out. Just a few things that came to my mind when I read this: I had fault-flnder considerable work trying to get the servers ready so that I could install backup software onto them.
Copyright -Tech Support Forum. Schuylkill Haven, PA Registered: When they tried to double-click on the share, they received an error message “The local device is already in use,” and it would not allow them to access the drive.
Thanks for your advices again, Wand3r3r. Wed Jan 28, The documentation does a great job of further explaining each as well as customizing the thresholds.
So why not just call the fault ID packet-size or alike? I’m willing to bet there is something on that port not set up the same.
Instrumentation Monitor The next fault-ifnder feature from HP is the instrumentation monitor.
HP Procurve Switch Faulting.
BB code is on. Do you have any legacy devices plugged into that switch, like old hubs or anything like that?
A High sensitivity means that fewer packets will cause the warning state, while a Low sensitivity means more packets.