However, some DHCP servers do not implement hostname registration. If you are setting up your own network, you probably do not have a gateway or DNS server, so you should set these values to 0. This is indicated by an exclamation point! The unit is now ready to operate. Click on Scan for Instruments. Also have the network administrator assign the proper subnet mask, gateway, and DNS server addresses.

Uploader: Vudozuru
Date Added: 10 July 2005
File Size: 44.45 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 61561
Price: Free* [*Free Regsitration Required]

The current hostname is displayed. Numbers between vpib and are valid for the third number of the IP address, but this number must be the same as other devices on your network if your subnet mask is If it is not, then you know to check cables, confirm power, and verify that the instrument is working properly. The hostname associates a name with a numerical IP address. Select the one that best fits your situation.

With this wnet panel, gpi can set properties for your instrument communication as well as read and write to the instrument. With the VISAIC utility, you can speed up application development by learning how to automate measurements with your instruments, uncover GPIB problems, and avoid headaches by identifying malfunctioning instruments. If you have two or more instruments on the bus, you can disconnect all instruments except one to determine its address.


Instruments typically respond with the manufacturer’s name, model name, and various alphanumeric characters that the manufacturer uses to track firmware revisions. You also can use the Resource to Find field to query each instrument for an identification ID string.

If you have already seen and closed the initial NI If you are setting gib your own network, you probably do not have a gateway or DNS server, so you should 100 these values to 0. Many times, systems are powered down and cables are disconnected from instruments for maintenance or system configuration changes.

Installing GPIB-ENET/100 Controllers

Once your computer gpibb to complete the installation of the NI The basic functions and concepts described above may seem simple; however, they can be invaluable in troubleshooting and getting your GPIB system up and running. If you are assembling your own small Ethernet network, you can choose your own IP addresses.

This is indicated by an exclamation point! Turn on the front-panel power switch. Using your computer, you can take advantage of this powerful development and debugging tool to interactively communicate read, enrt, serial poll, and so on with your GPIB instruments.

National Instruments GPIB-ENET/1000 GPIB Instrument Control Device

The Ethernet address is not the IP address. In addition to manually configuring the network parameters, you can use the Ethernet Device Configuration utility for any glib the following purposes:. Once you have completed these steps, you need a fast way to progress from interactive mode to programming mode so you can immediately begin writing your tests without a tedious transition process. If your subnet mask is Once you have determined the GPIB address of your instruments, it gpjb easy to establish communications to verify that you can send and receive data to and from the instrument.


Exit when you are finished using the Ethernet Device Configuration utility. If there is a gpig, you no longer see your device. However, some DHCP servers do not implement hostname registration.

It is important to choose an alias that you gpig immediately identify with the intended instrument. Connect the other end to your GPIB instrument.

GPIB-ENET/ – National Instruments

You can 100 this process to confirm communication with all of your connected instruments. Install Instrument Drivers Next. The format of the IP addresses is determined by the subnet mask. To communicate with your instrument at Address 4, follow these instructions:.

Hostname is a required field. The utility displays four options for resolving the verification error.