When you install the heat-sink assembly, do not touch the thermal interface on its underside, as this may result in damage to the thermal interface material. If the DDR2 memory modules are not installed in matched pairs, the computer will continue to operate, but with a slight reduction in performance. The sliding plate secures and releases the drive panel and helps to secure the drives. After you remove the heat-sink assembly, lay the assembly on its side. While you work, periodically touch an unpainted metal surface to dissipate any static electricity that could harm internal components. If the new floppy drive does not include shoulder screws, use the screws within the drive panel insert.
|Date Added:||17 February 2006|
|File Size:||14.15 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
After you remove the heat-sink assembly, lay the assembly on its side.
Do not set the heat-sink assembly upright or touch the thermal interface, as this may result in damage to the thermal interface material. If you are not installing a processor upgrade kit from Dell, reuse the original heat-sink assembly when you install your new processor.
If your computer includes a card retention mechanism, remove the top of the retention mechanism by pressing the tab and pulling up on the top. To connect a network cable, first plug the cable into the network port or device and then plug the cable into the computer.
Ensure that the tab on the processor cover is positioned underneath the release lever at the front of the socket.
To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network port or device. Otherwise, your computer may not start properly.
When you connect an IDE interface cable, do not place e50 colored stripe away from pin 1 of the connector. When you install a filler ee510, ensure that the bracket is seated correctly. If you are installing a processor upgrade kit from Dell, discard the original heat-sink assembly. For additional information on the type of memory supported by your computer, see your Owner’s Manual. To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components.
To continue using , please upgrade your browser.
To connect a network cable, first plug the cable into the network port or device and then plug it into the computer. Any address space reserved for these components cannot pdi used by computer memory. Ground yourself by touching an unpainted metal surface on the e501 of the computer. When installing the processor, do not touch any of the pins inside the socket or allow any objects to fall onto the pins in the socket.
pxi To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover. Cables routed over the cards can prevent the computer cover from closing properly or cause damage to the equipment. See the label on the module to determine the module’s capacity.
If you are not installing a processor upgrade kit from Dell, reuse the original heat-sink assembly when you replace the processor. Do not install ECC or buffered memory modules.
Instead, set the drive on a surface, such as a foam pad, that will sufficiently cushion it. The mounting-bracket screws need to be removed for the removal of the system board. Some network adapters automatically start the computer when they are connected to a network.
Specifications: Dell Dimension /E Service Manual
If you installed a processor replacement kit from Dell, return the original heat-sink assembly and processor to Dell in the same package in e501 your replacement kit was sent. Grasp the card by its top corners, and ease it out of its connector.
Gently pull the securing tab, grasp the card by its top corners, and then ease it out of its connector. When you install the heat-sink assembly, do oci touch the thermal interface on its underside, as this may result in damage to the thermal interface material.
When installing the heat-sink assembly, do not touch the thermal interface on its underside, as this may result in damage. If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure. Memory purchased from Dell is covered under your computer warranty. Leave the release lever extended in the release position so that the socket is ready for the new processor.
Snap the bracket onto the new drive. Your computer supports DDR2 memory.